Shorter Plastic Hypercube Z Bearing Carriage LM12UU
Description
Remixed this for my 400x400 Hypercube Evolution build using the dual z stepper motor setup. I purchased the plastic LM12UU polymer bearings instead of the metal ones. This is remixed due to the bearings I bought being shorter than other models. I also added inner rings to hold the bearings in without nuts and screws, but you may use them if you would like. Everything is a tight fit, so I used a rubber mallet to hit the bearing in after installing the part onto the metal rails. You will need to install the part and tighten the t-nut screws before pressing the bearing in or it gets in the way. Bushing Dimensions: 21.8mm x 21.8mm x 31.8mm Optional Hardware: M3x25mm screws M3 standard nuts
Statistics
Likes
4
Downloads
0