PanzerVNA - NanoVNA rigid case
Description
This is a rigid case for NanoVNA version with screwed stand-offs and Phillips screws (black one). No supports needed. After print You need to drill holes for LEDs with 1.5mm drill. Then using dremel and friction heat insert 1.75mm transparent filament to make a light tube (if it's too lose You can use CA glue to fix it in place). Cut excesses tube flush in front and leave about 4mm inside. I used transparent PET-G from Fiberology. Those light ducts are not necessary it will still work with drilled holes only. To screw everything in place You need DIN7991 M2.5x6mm socket countersunk screws. For lid You need small 4x1mm neodymium magnets - they attract to screws in top half.
Statistics
Likes
27
Downloads
0