Parametric endmill index/holder
Description
A flat, secure index (holder) for some cheap end-mills I picked up for cleaning support material out of recessed holes. Should be able to use the Customizer (in OpenSCAD 2019.05 or later) to match whatever endmills you have. Worked pretty well for a drill bit, too. Insert the endmills at an angle, then push down flat. Little ridges help ensure a secure fit, even if you turn it upside down and shake it a bit. To access a mill, push down on its bottom so that the tip pops upward and can be removed. (The first couple of times, a gentle assist from a small pliers might be helpful until the ridges wear a bit. Their fit is customizable.)
Statistics
Likes
51
Downloads
0