Coffee Drip Cone Adapter
Description
# ‘Adapter’ for #6 Drip-Cone (RSVP & Similar brands). [Re: Photo's - Don't know 'why' some are distorted but, you get the idea...] [UPDATE 10/11/2019: Replaced Upper with thicker version] The Adapter can sit on top of the Carafe and can be reversed for sitting on a Cup or Other Container. Also works as a Stand. Vent grooves provide Air displacement escape and serve as anti-rotation of the cone. Works on both 1 & 2 liter carafes (depends on Brand - tbd) For “PYKAL” / similar 2-liter carafes. For “FUNRUI” / similar 1-liter carafes. These also sit nicely on my other carafes and vacuum bottles. (It appears many Name-Branded carafes are the same/similar) [Note: I’m not endorsing any brand though, the PYKAL 2-liter is all metal , seals tight and is good quality] The #6 RSVP cone will accommodate both #6 & #4 paper and mesh filters. The Upper part is only needed if using upside-down and dripping into coffee cup. Otherwise, the Lower Part is sufficient for dripping into Carafe. Printing: I print at lower quality (to reduce print times), these are the parameters I used: 2 Top Layers 2 Bottom Layers 2 Shells Layer Height = 0.3mm Material: PLA Temp = 220 C Infill = 12%, Rectilinear Inner and Outer Print the two parts separately and Glue them together. Align the circular Vent-Grooves in Upper and Lower parts. Referenced #6 RSVP Cone: https://www.amazon.com/RSVP-Manual-Coffee-Carafes-Thermos/dp/B000BUDDTY/ref=sr_1_3?keywords=%236+coffee+cone&qid=1569529802&s=gateway&sr=8-3
Statistics
Likes
3
Downloads
0