Drill Master Carriage
Description
This carriage is intended for mounting the Drill Master rotary tool to a 3D X-axis for use as a CNC milling tool. I made this carriage so that I replaced my 3D Print head carriage with this one using that exact same hardware as the original. connected the ends of the belt to either side with tie wraps. Pulled the power cord through the hole of the smaller part from the bottom pulling the butt end of the tool pointing up. Then seating the tool end of the drill into the carriage then bolting both together with 4 20mm M3 screws with nuts.
Statistics
Likes
6
Downloads
0