Mouse roller for Everest Rampage Hawker mouse
Description
Replacement mouse roller for Everest Rampage Hawker mouse. To open it you need to unscrew three screws under the mouse skates. You need to use a 1.54 mm thick, 24 mm long nail (including head) as a roller axle. Drive it partially through the roller, shorten it and flatten it at the end to form a screwdriver edge 1.8 mm wide. Insert the roller in the yoke and drive the nail fully through the roller to couple with the roller sensor. It should rotate when you rotate the mouse roller and the mouse button micro-switch should not engage without pressing it. Do not forget about the roller cap and the roller tire - remove it from the original roller, clean it using alcohol and put on the replacement roller before installing it! This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/bOPKdVKYs47
Statistics
Likes
2
Downloads
0