EZOut and Filament Guide for Ender 3, Pro
Description
Remix of [nastyninjabear's excellent idea](https://www.thingiverse.com/thing:3416264) for combining a filament guide with an EZOut holder. This remix changes the original in the following ways: * One of the two screw holes for the EZout didn't align with the bracket hole. * The out end of the EZout on the bracket was about 8mm high and 2mm to the side of where it entered the extruder. This made the filament have to bent a fair bid in the small gap between this part and the extruder. * Stronger supports between where it attaches to the printer and the rest of it since it sticks out a bit from the printer and can get bumped. * Include needed files for the roller parts. Additional parts needed: * 608 bearing * M4x16 screw - nylon or steel * M3x12 screw - nylon or steel * Two M3 nuts * One M4 nut Assembly: 1. Press fit the 608 bearing into the ring. This may take some scraping away of the inside of the ring e.g. with the edge of a scissor blade. 2. Press fit two spacers inside of the 608 bearing. 3. Use the M4x16 screw to place the bearing in the arms. 4. Use the M3 screws and nuts to attach the ezout to the two holes on the bracket. 5. Attach the whole thing to the X stepper bracket as shown in the pictures.
Statistics
Likes
22
Downloads
0