Only Heel 55mm

Description

Here is my version of Fetish Heels. And also a lot quicker and easier to print than a full shoes with heels. The goal of these heels (yes, two will be necessary) is to add the constraint of the heels without having a complete shoes. The person who wear theses heels will have the toes touching the ground. So it's clearly not to wear on the street but can be very pleasant inside. To complete the print, you will need two little pieces of rubber (diameter 10mm) to glue under the heels in order to avoid slipping and two pairs of plate lace (one pair must be at least 140 cm). If you have very long laces (240 cm min), you can pick only one pair. I'll try to add a schema of the lace process I use but I'm sure that bondage addicts can find some good ways too ;) *Last but not least:* use at your own risks, and if you are not the one who will use it, make attention to print it the strongest way to avoid injuries if it breaks.

Statistics

Category

Tags