MiniCNC Plotter/Engraver - version 3 - Full
Description
As promised ... long awaited MiniCNC Plotter/Engraver version 3! (full set) MiniCNC Plotter or Laser engraver - decision is Your's Few words of explanation. 1. I used a steel rods from DVD player 3mm in diameter(some are good some better, longer better :P) 2. motors from DVD burner to drive belts 3. workspace size is limited by the mechanisms and it should be around 57mm by 57mm (not great but ....bigger than v1 and v2 ). Required elements (except printed parts :)) 2x DVD step motors with threaded rods obviously 4x ball-bearings 8mm outside diameter/3mm inside 4x steel rods min 100mm in legth (3mm diameter - from DVD drives) 2x steel rods min 60mm for Z-Axis 1x Arduino - any 2x RepRap stepper controller or any other whatever you like to controll motors some cables and few minutes to put everything together :P 1x laser or pen (8mm diameter :P) I hope you'd like it. ... small gratification/donation (few quid :)) would be nice for the design (paypal - in that case - please PM me, i'll send more details).
Statistics
Likes
225
Downloads
0