Solvol3D SV01 SKR v1.3 bracket replacement Motherboard
Description
This is a bracket I made for a following video on my Youtube channel, for replacing the motherboard on the Solvol3D SV01 to a SKR V1.3 32bits controller using Marlin 2.0 V2 - Moved the board 2mm away from the side of the case *** WARNING *** My printer had 24 volts between V- and the case ground, I have burned 2 boards and 8 drivers before finding this: The screws holding the power supply are too long and shorted out inside the power supply, I recommend that you take out 1 screw, measure the thread length, if it's 6mm add a couple of washers to bring the threads between 4mm and 4.5mm and do all 4 screws the same way. (See my pictures)
Statistics
Likes
21
Downloads
0