Replacement Belt Clip for Baofeng BF-T1
Description
Baofeng BF-T1 Replacement Clip ========================= This is a very quick and easy to print replacement belt clip for the Baofeng BF-T1 miniature Ham Radio. Not sure if other baofengs use the same hole pattern (3mm holes 28mm apart), but if they do this should be compatible with those as well. ~~Note that the part that the screws go into are a good bit thicker than the normal clip to simplify printing, so the screws are only threaded about 1mm into the radio. As far as I can tell this doesn't actually cause any issues, but if you aren't so lucky send me a message and I'll modify the design for you.~~ UPDATE 10/19/2019 ================ V2 has now been uploaded. It features countersunk screw holes, allowing the clip to sit farther from the radio, reducing strain on the clip from bending outward to fit on a belt. The edge of the holes have been chamfered at about 60 degrees to the vertical to allow printing without supports. the clip itself is slightly thinner, but does include a fillet to increase the strength of the joint.
Statistics
Likes
24
Downloads
0