Make the Ender 5 Corner Compatible - Screen and Spool Holders
Description
A screen holder and spool holder for the Ender 5, allowing it to be comfortably tucked into a corner. The original spool holder can also be used! The screen holder design is a little tricky to mount because of difficult access to one of the screws, but after mounting it it works so well I don't feel like updating the design. If you have a spare allen wrench you can cut the short end a bit shorter, and that will make installing this screen holder a piece of cake. I did use support when I printed the screen holder. Also, the screen holder .stl file is a little difficult to position correctly in cura. I had to use the "lay flat" command to get it to print face down properly. Check the first layer in the preview to make sure it's totally flat. The spool holder is specifically designed so that the area that holds the spool is centered about the filament intake hole on the extruder. If you have a slightly different extruder setup, you might want to edit the solidworks file. "M5" and "M4" refer to the mounting hole size. If you have solidworks, feel free to make changes!
Statistics
Likes
24
Downloads
0