Filament spool holder for dry box or stand alone
Description
You need: - 2x 8mm metal shaft (length based on holder number) http://s.click.aliexpress.com/e/nmJhl8JQ - 4x 608ZZ Bearings for each holder http://s.click.aliexpress.com/e/20qgDwwM - 4x M8 screws http://s.click.aliexpress.com/e/kQ1Mclve You have to print: - 1x "Holder.stl" for each holder You want - 2x "Pipe.stl" for each holder OR - 4x "Pipe_half" for each holder I printed "Pipe.stl" without adhesion options, like in pic, horizontal. But if You have adhesion problems, You can use brim or raft. In this case, probably You have to sand down to have around pipe. Otherwise You can print "Pipe_half" and glue 2 of them to have 1 entire pipe. You can tighten the M8 screws in the shaft crushing a little bit the end of shaft. Consider that it must not withstand strong pressure For dry box, I used too: - Thermometer hygrometer holder https://www.thingiverse.com/thing:3902406 - Angled Dry Box Feeder https://www.thingiverse.com/thing:2116535 - Desiccant LockBox https://www.thingiverse.com/thing:2536221
Statistics
Likes
16
Downloads
0