House-of-Ramps_200
Description
House of Ramps 200; all parts suitable for 200mm hotbed !!! Board-carrier 2-part, joint 0.3mm, can be glued with UV-glue or Cylamatglue. Board carrier provided for Anet board (with adapter), ramps, re-arm and SKR mini V1.1 , each with 5 smoother modules. Furthermore for Tangoboard V1.0, for thc-01 extension. All parts are printed by my self, so printable !!! The parts shown in green are compatible with Haus of Ramps. On request I can also the top and the fan housing, for house of ramps rework and upload. The board was mostly redesigned (40mm fan, location of the Smoother, top mountings). The parts labeled Anet are adapters for the Anet-board, as well as original power supply (25 Amps). Will put an SSR between later. Have already installed the appropriate firmware (Marlin 2.0). The new power supply enclosure is designed for 3 pairs of supply lines with a cross-section of 4mm. 2 pairs for Mosfet Heatbed and 1 pair Mosfet Hotend. I used rigid wire for that. Furthermore, there is a stop for the power supply
Statistics
Likes
8
Downloads
0