Prusa Steel Anti-Wobble For 8mm Z Axis, No bearings or screws
Description
This is my attempt to fix the very annoying z wobble that i was getting on my prusa steel build, i didn't have any bearings and i couldn't print one of the bearing mounts if i wanted to because of the way my bowden extruder is set up, so i decided to create my own quick fix. I recommend also printing solid Z couplers as well. Keep in mind that this is a very tight fit so you will have to adjust the scale until it just slips over the leadscrews and has very little play between the leadscrew and the hole in the frame. In my case, i printed on my ender 3 pro and it fit perfectly without any adjustment, your results may vary. I would not recommend printing this on the prusa steel if you have z wobble issues as the banding/ layer shifts may cause inaccuracy in the scale. If you don't have another printer you could always just sand it down and file the inside though.
Statistics
Likes
4
Downloads
0