Anet A8 18mm Sensor Holder (Front)
Description
Made for capacitive/inductive sensors like the LJC18A3-H-Z/BX sensor. Screw diameter: 15-18mm I am using this with the Titan V6 upgrade: https://www.thingiverse.com/thing:2668549 Check out the original design by LucaCap: https://www.thingiverse.com/thing:1852762 I remixed this for 2 reasons: 1.) The original design wasn't strong enough to hold my sensor. 2.) The sensor was too low down (and if I tried the screws at the top it was too high up).
Statistics
Likes
5
Downloads
0