PoleMaster-Star Adventurer Adapter Adapter
Description
This thingy is not a stand-alone adapter. To mount a PoleMaster to the Star Adventurer, you'll need Skippy's PoleMaster-Star Adventurer Adapter (http://www.thingiverse.com/thing:3290513) and the PoleMaster must be fitted with the generic adapter. My PoleMaster is meant to mate with the iOptron CEM60 adapter. With or without the CEM60 adapter, it doesn't fit Skippy's adapter. This adapter will fix that. The backside of my PoleMaster can be seen in photo #3. My adapter fits here and into Skippy's adapter. If the backside of your PoleMaster looks like mine, this might work for you... check the pictures. After printing, I drilled a hole through the side of this adapter so the set screw from Skippy's adapter passes through to brace against the PoleMaster. The adapter is made in two parts held together by a M4 nut and bolt plus a toothed washer. It seems a little stronger than if it was made in a single piece and reduces some support requirements. I used PLA for both Skippy's adapter and mine. There are quite a few variants of the PoleMaster adapter. My only model was the CEM60 adapter so I included my FreeCAD source file; it might be a starting point to make modifications for your own specific PoleMaster adapter.
Statistics
Likes
2
Downloads
0