Portable Poker Set
Description
This is a case for a deck of cards and some very cool 3D printed poker chips by felixleong (⬇see credits⬇). It uses 2x 2.5mm by 14mm refrigerator magnets and 1x 19mm by 25mm hinge. You will need to print one of each file (poker chips are optional). For the magnets: glue the magnets in the fitting holes on the smallest part and the main bottom part, but make sure they are orientated so that they don't repel each other when the magnets touch because it is to keep the box shut. For the hinge: glue it on the back of the two main parts in the slots opposite side from the magnets, not using the holes. Make sure the hinge is facing in the right direction so that the box can open and close on the hinge. (I used hot glue, but you can also use super glue, whichever you prefer). Finally, glue the "lock" part in the small square on the front of the lid (the square is to indicate where to place the "lock" part). PS Sorry about the squished photo. Thingiverse did that
Statistics
Likes
20
Downloads
0