LCD 2004 Display Holder (e.g. Anet A8)
Description
Printed in PETG. Actually added a small 0.3mm surface to the bottom of the 10 screwholes because I had problems printing it. Removed this again for upload. I used 5 M3 18mm screws to screw it to a Ikea LACK table and 2 M3 8mm screws to screw the display on. (Yes I did not use all screwholes, only the ones closer to the edge of the table) I will design a cover to put on the display in the future. PS: When pushing buttons the whole thing goes down minimally. But you can just put one or two screws in the side of the table to (probably) eradicate this completely. (Not tested, for me it is sufficient as it is)
Statistics
Likes
1
Downloads
0