D6 holder
Description
holds 25 x 16mm 6 sided dice, Other material required: -3M screws 10mm with nyloc nuts x 5 -some cord -A cord lock toggle the knot stopping the cord being pulled through the center hole is hidden under the bottom plate, use a lighter or something to partially melt the cord ends together and shrink it a little so it fits in the gap print instructions: all parts need support, i would advise at least skirt on the main body maybe even on rafts depending on if you commonly get the "elephants foot" problem on your first few layers the 2 ends are a couple of hours and the body is around 12hours i print them at 0.2 layer and at least 3 walls
Statistics
Likes
27
Downloads
0