Cross RC BC8 Electronics Mounts
Description
Boards designed to clean up the mounting and wiring inside the Cross BC8 Mammoth. I will keep adding to this as I get them done and tested. The RX_ESC mounts the Spektrum SRS6000 6 channel receiver below the HobbyWing 1080 ESC. It uses 3mm x 8mm screws to secure the top and servo tape to secure the ESC. There is also a hole to route the antenna wire through into some 3mm rx tube. The Sound_Lighting_Servo print stacks the Cross sound module with the lighting pc board and the servo power board. the screws are M3 for the sound module and power board. The H shaped cover over the lighting PCB uses M2.
Statistics
Likes
10
Downloads
0