iFlight XL8 v3 DJI FPV System Parts
Description
The iFlight XL8 v3 frame can easily fit the DJI FPV System camera and Air Unit with minimal modification and a few TPU parts. The rotor arms do need to be mounted under the bottom plate to leave enough space for the stack and Air Unit, but other than that, just add TPU and DJI parts. The GoPo Hero7 mount requires 2x 15mm standoffs in the middle section for the sides to screw into (thank you whoever I stole this idea from) The build shown was for the full DJI stack and so didn't use an RX antenna, but I have included the STL for a Crossfire Immortal-T mount that sits under the bottom plate and attaches with the standoff screws.
Statistics
Likes
22
Downloads
0