Adapters for balancing self-tightening 6mm DJI blades (OBSOLETE).

Description

This Design Has Been Updated. See: Http://Www.Thingiverse.Com/Thing:737600 ~~~~~~~~~~~~~~~~~~~~~~~~~~ This File Will Print End Adapters For 3Mm Rod For Balancing Self Tightening 6Mm Ccw And Cw Blades As Used On A Dji Phantom Ande Others. I Used Polished 3Mm Tool Steel Rod I Bought On Amazon, About 6" Each. The .Stl File Prints Two Sets Ccw And Cw. The Photo Shows Two More I Also Printed From The File "End_Cap_Adapter_For_Phantom_20_X_8Mm.Stl", By Jjisnow. (Dji Phantom 2 Prop Balancing Adapter For Dubro). I Used Abs And Mark The Ends Of The Two Ccw Pieces With A Black Sharpie. My Design More Closely Emulates The Actual Thread Ends On Dji Phantom 2 Motors, The Relief And Thread Length. I Am A New Guy To This And My Prints Still Come Out A Bit Rough And Oversized, Holes Too Tight, So I Resorted To Using Dies To Clean All The Pieces Up A Bit And Reaming Our The Hole For The 3Mm Rod. If I Figure Out How The Get It Right Without Finish Work, I Will Update. In Order To Get The Part As Accurate As Possible, I Used .100Mm Layers And Slow Printing Speeds. I May Have Calibrating And Other Issues That I Do Not Understand Yet, But My Prints Come Out A Bit Rough And Need Cleanup. The Brim Is Not Part Of The .Stl File. I Added Them When I Print To Help Keep Them Upright While Printing. They Come Off Easily.

Statistics

Category

Tags