Name Your Price Tool
Description
My wife was dressing up as Flo from the Progressive commercials for a Halloween party. I could not find the Name Your Price Tool anywhere on any of the usual sites. I found a decent diagram that I used to help me sketch this up in Fusion 360. I printed it and found out the pins were a little too big/long, but I adjusted them before uploading here. The top pieces ended up being a bit thin in the back. I made them a little thicker. I have not tested them, but they should print fine and be better than the ones I printed. Support is only really needed for the body pieces. Where the trigger goes, there is a very slight overhang. You may be able to get away without support, but better safe than sorry. So you just need to print one of everything, except the pins, those you need 9 of. Then I used some 5 minute epoxy to put everything together. It held up great at the party. This is really more of a prop than anything else, so the front is not open, like you might find in pictures. I might revisit this and maybe integrate a laser pointer into it? We shall see. Enjoy!
Statistics
Likes
3
Downloads
0