C.L.S Can Launch System
Description
A brief jaunt into the land of rocketry using materials found in your very own home! works well with any Estes motors, included sized are A, B, C, D, E tubes This completely modular can-clip system can be used to build your very own can rocket! Parts include can clips, nosecones, motor tube attachments. ======!! Disclaimer: This system contains no parachute recovery system, these things come down fast and can potentially be dangerous, make sure the area is clear and you have taken necessary precautions before launching !!===== Print the motor tube sideways to maximize the strength of the part, otherwise, print the pieces flat side down. the main can clips print best with support material, I recommend printing them with the cup-side-down as the lower clip has tighter tolerances than the upper. I tried to minimize can manipulation but you will have to cut out the bottom of your fin *can* to fit the motor tube, please don't cut yourself. The motor tube slots into the motor clip, so if your motor tube breaks you only need to print that piece! Anything from cardboard to sheet plastic works well for fins, normally eyeballing their spacing is fine, just make sure to have more than one, equally spaced on the fin can. https://youtu.be/JUAriyLF7b8
Statistics
Likes
7
Downloads
0