Drill Press V-block 2.0
Description
Decided to improve the V-Fixture for printing. This is intended for use on a small drill press to hold rods. I changed it because of issues I have had during my prints. The old design was best printed standing up but this caused a very long print and my filament tangled at 75 completion. Flat prints left the V section weak when I left supports off. This was much easier to print and I won't have to stand it up. 4 in x 4 in x 1.25 tall, with 45 degree V and a .130 diameter centering hole.
Statistics
Likes
69
Downloads
0