Improved!! v2.0 brock Ethernet Cable Strain Relief, dual row, clamping
Description
This clamping strain relief device is used to hold ethernet cables in position behind a rack, NVR, hub or modem. Specifically for the NVR it is important to put the cables back to the same position when reconnecting and this clamping strain relief achieves that. It holds each cable in position while at the same time providing strain relief through the collective stress of all the cable connections. Whether you are unplugging one connection or all connections from your hub or NVR this device is helpful in managing and restraining the cables. Should work with most cables and will provide some gentle clamping on most CaT5e and CAT6 cables. The 10x (10 slot) model allows 10 cables to be held which I use as 8 camera connections and 1 lan connection. I am including configurations of 10x, 8x, 6x and 4x. More information about this design. and many many more, on my blog site... https://logicalplant.com 2019-11-05 Release much improved v2.0 - Strengthened the pivot axle by increased the diameter. I found it was relatively easy to break if you tried. - Added cable retention to the slots making it much easier to load the clamp. Previously cables would be difficult to hold in place while loading it. - Reduced the total amount of material needed to make by increasing the diameter of the holes through the main body. 2020-0214 12x version added.
Statistics
Likes
32
Downloads
0