Raspberry Pi Zero Enviro+ Sensor Case
Description
Modified the @adafruit Raspberry Pi Zero Case ( https://www.thingiverse.com/thing:1165227 ) to be taller to accommodate the Pimoroni Enviro+ sensor. Then created pilot holes to connect cable runs and a case for the supported particulate matter sensor (PMS5003). Included an (untested) mount for the Raspberry Pi Camera Stand by @atleberg ( https://www.thingiverse.com/thing:274111 ). This is all pretty tightly fitting - you may find luck scaling up your prints slightly. The mating holes are not meant to secure the pieces together - but rather help place them during gluing / plastic welding them together. This is all a work in progress. I'm wanting to build an environmental sensor case that can accommodate multiple use-cases.
Statistics
Likes
23
Downloads
0