Beat Saber Darth Maul style VIVE controller mounting bracket
Description
Hello fellow 3D print fans. I'm a huge fan of Beat Saber, Darth Maul style. I had a VIVE controller bracket, so i could use my VIVE controllers. But i thought it was too big in the diameter, where you have your hand, and it was too short in length. So i designed a "vive controller bracket" so i could mount two pcs. VIVE controllers on a Ø25mm (about 1 inch) Wooden Dowel Rod. My Wooden Dowel Rod is about 45 cm long But cut it up to see what length fit you best. Remember to screw on the two bracket 180 degree from each other. I printed it in ABS. 20% infill, 4mm triangles. The Lock clip i made with 100% infill. Even i have been swinging it for hours i have not broken on me. You can also tie the lanyard around the rod. My Ultimaker printed it ok without support. Really, really good and fun exercise!!! Do not go near someone playing Beat Saber Darth Maul style :-) Beat Saber Darth Maul style is---> https://www.youtube.com/watch?v=Eha9nDJ62i8 (not me in video...not even close :-) )
Statistics
Likes
3
Downloads
0