Duet Maestro Enclosure (Quad Fusion Ready)
Description
This enclosure will fit most 2040 aluminum frame 3D printers and is Quad Fusion ready. Will also fit most current Duet boards. This comes with 2 lids. One regular flat lid and one lid that will still fit once the expansion board for the Quad Fusion is plugged in. The Quad Fusion Ready lid will use a lot of support filament during printing however you can flip it over if desired to reduce the amount of support used during the print. Both lids will slide on the enclosure and has ample room for wire management. This is a remix from MegaAndy but has the following fixes in place. - Board is centered more towards the center on the enclosure. - SD card slot is much larger to allow for removal of SD card and has easy access to all ports. - Reaching the screw holes is no longer an issue. - Added rails to help the lid slide better while closing. Hardware used to mount to printer. 4 - M4-0.70 x 8mm 4 - M4 T-Slot Nuts Hardware to mount board to enclosure. 4 - M4-0.70 Nylon Lock Nuts (Used these so they don't come loose during a print.) 4 - M4-0.70 x 16mm I purchased all hardware at the local Home Depot.
Statistics
Likes
6
Downloads
0