Ender 3 PI Touchscreen Housing right side REMIX
Description
I remixed Tronnic's Pi case, what's different: 1. Flipped to fit on the other side where the original ender screen was 2. Made wider so you can put a 40mm fan on it while the pi ports are on the right side. 3. cut away the sd holder + some other excess. I used this to replace the stock ender 3 screen with a Pi 3.5inch screen from aliexpress, i paid 9 euro from the screen and it works amazing, i also used Klipper + octopi to make this display the main setup for the printer, z-offset i can change directly from octopi using Klipper, klipper has a config file which you can setup from octopi. i suggest using octoprint-tft or octoscreen for this setup, don't use TouchUI I'm no Pro, but i tried my best, there is a very small leftover spot from where the old hole for the screw used to be, which is not really a big deal, i actually sanded the bottom side and painted it smoother black, while i left the top stock, it looks good, you can see it on the pictures, also the extension piece doesn't 100% go flush with the ender bracket but i did my best again, also visible on the picture, none of this is very noticeable tbh. Original: https://www.thingiverse.com/thing:3030160
Statistics
Likes
29
Downloads
0