Daya 680 Pixhawk/Cube Cover
Description
This print is intended to be used with the stock Daya 680 standoff locations and a Pixhawk/Cube flight controller. If you want to use on a different frame make sure the Standoffs are a maximum of 7mm wide by 22mm long. They should stand 52mm in width apart and 112mm in length apart. Printed diagonally on a Ender 3 with a bed size of 235mm by 235mm. next revision will include a lighter design and single GPS that is permanently mounted with a secondary that can be easily added and removed(For RTK).
Statistics
Likes
9
Downloads
0