Peon 230 landing gear
Description
This is a snap-on landing gear that fits into the rectangular holes on the [Peon 230](https://www.thingiverse.com/thing:629338)'s arms. It takes some force to push it in and will stay in even on hard landings. It works best though if coming in for a landing straight down. If the drone is moving forward on the landing, the front two legs can collapse in. I am currently working on a v2 which will clip in, so it will not come off in a crash. There is 50mm of clearance underneath the quad, enough to put a small flashlight or to just lift it off of the ground for takeoffs and landings. .2mm layer height 20% infill no supports (print it laying flat) print 4 (one for each arm)
Statistics
Likes
3
Downloads
0