Rastar Mustang GT500 - Servo Steering
Description
This is a remix of my Rastar D90 steering kit, it's been tweaked to fit in the front of the Rastar GT500. Fitting instructions are the same so check out the D90 page where there's a video that's largely the same as the GT500. Photos will hopefully be added before too long. It mounts using 2 of the self tappers from the model and requires a couple of other minor bits to get it working. Slec ball ends: SL072-S (http://www.slecuk.com/balsa-wood/Minature-clipable-ball-link-6-per-Pkt-SL072_S.html) M3x6 screw 2x M3x8 screws 15mm M2 threaded rod Alternative Tamiya parts: 4mm cups 0445563 4mm balls 50590 For the most part it's a simple direct fit, there's a small amount of plastic that needs removing from the chassis, it's pretty obvious what's in the way once you fit the adaptor to the sliding linkage. The distance between the centres of the ball cups should be 20mm. It's also not a bad idea to print the adaptor with 100% infill. 35% is more than enough for the other bits. Oh and lastly the main mount is the right way up for fitting to the chassis in the STL file, but it's a lot easier to print if you flip it upside down!
Statistics
Likes
6
Downloads
0