MDB6601AWQ Dishwasher Handle
Description
V3 Update: This will likely be the final version unless I actually learn how to do proper 3D modeling. I've removed V1 and V2 since they didn't really fit properly after all. V3 allows for a proper door seal without any fuss. There's definitely still room for improvement, but for me this is good enough. The wonderfully designed handle by Fluxcapacitor fit my MDB6601AWQ Dishwasher on the inside, but was just a bit too large to fit through the opening. I resized the handle a bit, and got it to fit much better on my first try! I'm sure there could still be improvements, but it works for me. This replaces the handle that apparently cannot be ordered seperately in part # WPW10130695. I printed mine with a resolution of 0.15mm/layer and 100% infill, but that's probably overkill as long as you're using enough perimeters. When installing, just make sure the latch isn't set, or you'll have a hell of a time trying to get it in place. I just used a screwdriver to open the latch on mine, then it snapped right into place.
Statistics
Likes
2
Downloads
0