Roll Support for Spools - Ender 3 - V2
Description
Version 2 (V2) I made a smaller version, so now it fits smaller spool holder holes. It fits as low as a internal spool holder diameter of 56mm If you like my designs, please support me. Even $1 is fine :) paypal.me/bmabma --------------------------------------------- The original spool holder of Creality Ender 3 has a diameter (30mm) too small in comparison to the spools i've been using (74mm) so I did this support. There are 2 supports that are clamped to the original spool holder, and each one has 2 rolls on the top that make contact with the spool. No need to use bearings, bolts nor any extra part, just print it! I used 0.2mm of layer height, 0.20 infill and tree supports You need to print: - 2x Roll support for spools - Ender 3 - CLAMP - 4x Roll support for spools - Ender 3 - ROLL
Statistics
Likes
242
Downloads
0