OneWheel Stand XR Pint V2
Description
This is a remix of TH-Props design. Thanks much to TH-Props! Here is the link to the original: https://www.thingiverse.com/thing:3273259 Just reinforced it a bit and made a spot for the ultra charger to sit behind the stand. Also added a downward slope on each side to better balance the board once on the stand. Printing: I would recommend at least 3 lines of shell and 20% infill in PLA but best would be in ABS. Minimum of 10-15 top and bottom layers. Print sideways for best strength. It is currently 200mm wide. If you need to accommodate a onewheel with extra plates attached, elongate the stand as needed on the Y-Axis. **UPDATE V2: New version accommodates "thicker" boards that have a higher kick tail and float plates (for a better angle - not too vertical anymore). Also added a blank logo version and some fun logo versions.
Statistics
Likes
97
Downloads
0