Tevo Tarantula Pro x axis tensioner
Description
UPDATED: Added a second tensioner for a Gates GT2 idle This is a remix of the x axis tensioner by ivango2. I had an issue with the original fitting and pivoting around the bolt head for the z axis wheels so I expanded the pivot 2mm. I had to drill the idler bolt hole slightly to get the 4mm bolt to start and thread into it, so I updated the idler bolt hole so that it is slightly bigger and is easire to get the bolt installed. I narrowed the idler gap slightly so that the idler is a snug fit with the idler. if the gap is too tight, then a little light sanding can be done. I modified the body slightly so that there is more material for the idler bolt to bite into. The body of the tensioner is flat on the back to allow printing without supports. The original knob was not deep enough for the carriage bolts that I had so I made it a bit deeper. I increased the diameter of the end cap and made it a little deeper so that it should snap into the knob. parts neeed 1 - 5/16 "x 1.5" carriage bolt 1 - 5/16 nut Idler pulley and screw from the original kit without the nut, washer or spacer. parts neeed for tensioner with Gates Powergrip 2GT 20 Tooth Idler 1 - 5/16 "x 1.5" carriage bolt 1 - 5/16 nut Gates Powergrip 2GT 20 Tooth Idler and M5 x 20 socket head cap screw Printed on my TTP for use on my TTP. Let me know if you have issues fitting
Statistics
Likes
67
Downloads
0