Drybox FilaScrew (Filament Guide for PTFE tube) for IKEA Samla
Description
The FilaScrew is a simple yet elegant way to guide filament from your drybox to your 3d Printer. Simply drill an 8mm hole in your drybox, Print the Filascrew, Source a rubber gasket from somewhere (Mine was from a Dutch "Grolsch Beugel" beerbottle). Drill out the center hole with a 4mm wood-drill, Insert a 4mm PTFE tube and you're ready to feed some filament to your printer. Tip: If the threading gives you a bit of trouble, apply a bit of grease to the inside Nut.
Statistics
Likes
42
Downloads
0