MPDM Microswiss all-metal hotend mount
Description
This will mount the MicroSwiss all metal hotend ( https://www.amazon.com/gp/product/B0789V2D7C/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1 ) to the existing effector plate on the Monoprice Delta Mini. I used PETG and printed with supports. You will need a little bit longer of screws for the top of hotend than comes in the kit. (18mm+ length) Fan screws work just fine. I have been playing with the cooling and this is about as good as I am going to get it. Maybe someone can improve on it! Created on Tinkercad so unfortunately I can't share the source files. Not totally sure why the pictures are all squished and sideways...lol ~Zuk3D *UPDATE 12/21/19* I completely changed up the design to fix the print cooling issue and am very happy with the result!! I moved the fan from the front of the hotend to the back, redesigning the front cover to capture 100% of the cooling air to direct back toward the part. After several 'benchys' and other prints, this is a much better design than my first. I will leave both up. I split the cover into 2 for easier printing with minimal supports, but Ill leave that up to you. I found it easiest to install the square nuts after heating them up with a lighter. First install them, then thermistor wire through the holder, put the hotend close to final installation point then install the heat cartridge, connect throat to the heatbreak, put on the silicon sock THEN mount the hot end in holder. Kind of a pain, but the results have been awesome!
Statistics
Likes
12
Downloads
0