ECX Barrage - Axial SCX10 Skid conversion
Description
This is a skid remix from another model to fit an Axial SCX10 transmission onto the ECX G1 barrage. The transmission w/ motor was cheaper to buy than the actual ECX upgrade G2 Motor Plate and 390 motor. i had to raise the transmission a little so it didn't hit the metal rails. I used (4) M3 x 20mm screws to bolt my trans to the skid. Please note, I modded the model after I printed so that the screws will be sunk in the skid as not get caught on anything you are climbing. The side holes are slightly off. I am not sure if it was in my printing or since it was some else model, but they can be "loved" in. Lastly, I used PLA and have not had any problem yet. your mileage may vary.
Statistics
Likes
6
Downloads
0