Philips Hue Motion Sensor - holder
Description
Designed a quite simple holder for the Philips Hue Motion Sensor that sits over the door. With a 20 degrees angle, so there is bigger chance of the sensor too recognize someone at the door. The magnetic part screws into place using a normal M3 screw through threaded hole. And the lip gets squeezed between the wall and door seal. Therefor I uploaded 3 versions (1, 1.5 & 2 mm lip - of thickness). Also the length of the "lip"/the part that gets between the door seal is 11 mm. (more sizes on request) I used the 1 mm and that was good enough. No needs of support of any sort. Infill is suggested. I printed mine with 20%. Bracket/holder for a corner, can be printed as imported.
Statistics
Likes
8
Downloads
0