parametric book display stand
Description
I made this book stand for my wife, so she can display her books properly at a fair. Just enter the dimensions of the book (or other stuff like DVD-boxes etc.) and optionally adjust the height, width or angle of the stand to your taste. You can also simply add a frame, so the stand is able to hold loose sheets of paper, like flyers. Wall thickness when printing should not be less than the value for "t_wand" in the SCAD file. You can print it without any support or infill. In most cases the stand is rigid enough. If you still want to increase stability, simply drill a hole in the bottom, fill it with sand and close it again with hot glue.
Statistics
Likes
3
Downloads
0