Dropped Pin Magnet
Description
This is a 3D printable "dropped pin" magnet. There are two 3 mm holes on the back for cylindrical magnets to fit into. You will need to use a 3 mm drill bit to widen the holes in order to fit the magnets in -- this was intentional, as different 3D printers are going to have different printing tolerances. You can purchase a pack of 3x3 mm round cylindrical magnets from Amazon for cheap. While you are here, if you made this thing and you liked it, please consider giving a tip. As a college student, I would greatly appreciate it, thank you! Note: This part file is digitally watermarked. Verify watermarks at https://www.watermark3d.com
Statistics
Likes
6
Downloads
0