AnyCubic i3 Filament Sensor Mount and Loom Strain Relief
Description
Replaces the magnetic filament sensor holder on the AnyCubic i3. Also holds the cable loom and provides neater wiring :) Remove the magnetic half-dome bit off the printer and replace with this (using the same screw). Pop open the sensor housing, remove the magnetic ball part and close (optional). Add the cable from the sensor into the main loom for neatness (optional). Requires 2x M3x16 bolts to attach the sensor to this mount (nuts not needed). No supports needed, printed at 0.2.
Statistics
Likes
19
Downloads
0