Nasa Viking Lander Remix
Description
Nasa Viking Lander - Remix. Note: the model in the photos was printed at low resolution and not fully cleaned up as it was a rush job for a teacher. Top and Bottom have been hollowed out to reduce material. The Thruster part was separated out to allow printing in gold or brass. The gussets on the legs have been reduced to produce a more realistic look and save material. In addition, an optional two-part leg has been made to allow the top shock-absorber to be printed in white. The flag emblems were created by cutting a rectangular mask in electrical tape and placing it on the model. Use a fine-point blue marker to dab the top-left area leaving white "stars" then use a red biro and ruler to draw the stripes. Finally, cover the emblem with Bondic UV-cured clear plastic to prevent smudging. This task was also a rush job so could be much neater. Antenna centre is Tool1_C trimmed. Tool1_B should be printed in black.
Statistics
Likes
14
Downloads
0