DJI Inspire 2 GoPro Mount (Adjusted)
Description
Adjusted Aegir's GoPro mount to make it a little less tight on the mount (it was STIFF to mount) and made the holes a bit larger to allow threaded M5 to go right through as with other GoPro accessories. YOU WILL NEED an M5 nut to secure the other end of the GoPro thumbscrew. Big thanks to Aegir for designing this! Printed at 0.1mm layer height with supports enabled, especially for the GoPro knuckle and the lower two slats of the Inspire 2 camera bayonet mount. The default orientation (on its side with the knuckle printing horizontally and rotated around X axis at a 45º angle) aids in strength vs standing it upright and having layers cut horizontally across the knuckle, where they could easily snap during flight. I would consider printing this larger and annealing it for added strength, but I don't think it will suffer a RUD given typical GoPro mass and flight dynamics of the Inspire 2.
Statistics
Likes
21
Downloads
0