Action camera TPU case
Description
hello all :) I needed light protection for my action cameras (eken h9 and h9r ) that allow me to drop them without any fear and allow me to use them with power banks instead of the included battery but of course, you can use it with the battery if you wish that. ------ please note the following:- 1- USE IT WITH CATION AND AT YOUR OWN RISK. 2- this case may work with other action cameras like the sj4000 and others but I AM NOT SURE ABOUT THAT someone please confirm it with name of the camera please in the comment section thanks. 3- you need to reorientate the part in your slicer before printing it. 4- please note that my printing setting work for me and may not work for you feel free to use your own printing setting. 5- be careful when removing the prints especially the buttons as they have a small membrane 0.3mm. ------ This case will give you basic protection for your action camera if printed probably. please note that the infill I use is 15 % but you can increase it to 100 % for extra protection. I did print this with my modified cr-10 with Chinese TPU at 60mm/s speed and 0.2mm res. you may want to decrease the speed to 15-20mm/s and the res to 0.12mm to make it work on your printer. please do not use any support or bed adhesion and be careful when removing the prints especially the buttons as they have a small membrane (0.3 mm thickness ) that is a functional part of the design to prevent the button from falling down after the camera been installed.
Statistics
Likes
3
Downloads
0