MK3S LED Nozzle Duct
Description
Simple way how to lighten up the nozzle of the printer. The nozzle duct/shroud is based on the original Prusa MK3s model, there are slots for 3 mm LEDs, use whatever colour you like. To get it working you will need a pair of 3mm LEDs, an appropriate resistor according to the power supply. The wires connecting the LEDs is 100 mm long. I am powering it up from (Vcc and GND pins) the Einsy board, so the cable from right LED to the motherboard is about 65 cm. HOWEVER, do your research first and chose the best wiring setup for your case! There are two 2mm cable ties used to secure the cables (see the pictures). If you want to use the cable holder on the right side, you need to replace the bolt with 25mm one. Enjoy! :-)
Statistics
Likes
3
Downloads
0