Kingroon Main Wiring Clamp
Description
Picked up a Kingroon KP3 Printer off Amazon to use as a dedicated PLA or small parts printer. The wire management clamp used on the printer broke due to thin walls around the bolts. My design is based off the stock unit, I just left a bit more area for strength. There are two versions; Power_and_Control_Wiring_Clamp_KingRoon_v1 This was my first attempt which requires longer screw hardware... if you print this, please keep this in mind you will need longer screws to attach to the t-nuts. There is not a lot of room under the build plate to get to this area... Power_and_Control_Wiring_Clamp_KingRoon_stock hardware This uses the stock hardware. You should not have to get anything different, direct replacement.
Statistics
Likes
19
Downloads
0